![]() ![]() RESTART - Stops and Starts the PowerFolder server.STOP - Shutdown the PowerFolder server.If you don't configure this parameter the server won't find its Java executables and will state this as the error in Log Files of systemd.Īfter doing all the above steps you can control your PowerFolder server with systemd the supported commands are You need to show the file where PowerFolder is installed:Į.g.: SERVER_INSTALL=/home//PowerFolder-Server This can only work when editing the PowerFolder-Server.sh file. Go to the installation directory where you extracted the contents of the the installation package. ![]() Since the basic preparations are now finished, you can continue to start the installation: Later migrations from the internal database to an external one is currently not supported, therefore this one should be considered before setting up a live environment. The steps needed to set this up, are described in our database setup guide. In larger installations or when planning a scale-up over time, we recommend to use an external database. There is no additional setup needed for that, since it is running out-of-the box if no other external database is defined. Using an external database (Recommended)įor evaluation purposes and in small to mid-sized installations you use the internal database which is delivered with PowerFolder Server. tar.gz file with the command "tar zxvf .ģ. We recommend to place the program files into a sub-directory of your home directory, e.g. The process of creating a user and a home directory for that user is described in the first section on this page. tar.gz file in the home directory of the dedicated user for PowerFolder Server. tar.gz distribution for Linux based servers from our server release notes site. Download and extract the installation package On most Linux based systems the process of creating a user and a home directory for this user can be accomplished by a simple command:Ģ. We recommend to create a dedicated user for running PowerFolder Server on the system and create a home folder for that user, where you place the program files and resources as described later on this page.If not, please contact your system operator to assist you or take a look at our managed Cloud Server products. You must be able to operate a Linux command prompt to continue.You will need the account email you requested/purchased with and the current password for the account to activate the server. Make sure you either requested a trial license or purchased a commercial license for PowerFolder Server.Further details can be read on the Server System Requirements page. Please check the minimum requirements, which are necessary to install and run PowerFolder Server.This guide describes how to install PowerFolder Server on Linux based operating systems.
0 Comments
Leave a Reply. |